Hello, welcome to the official website of KDP MACHINERY JIANGSU CO.，LTD.! Phone：0510-86578805
Precautions for using steam ejector?
Release time:
2022-07-26
In a word, you can come here for some information about the precautions in the operation and use of steam ejector. After reading the article, if you encounter this kind of thing, you will know which way to choose. I hope it can help you.
To keep the steam injector in good working condition at all times. It is necessary to master certain maintenance knowledge. Today, I will tell you about the precautions in the operation and use of steam ejector. If you want to know about these problems, please come here to understand.
We can see from its name what it is used for. As a mechanical equipment, it has many advantages and functions, but there are also many matters needing attention during operation. For example, before using the steam ejector, the user should carefully check whether the power supply, voltage, water supply and drainage, safety valve, pressure gauge, water level gauge and air supply pipe accessories are sensitive and easy to use. Close the drain valve and open the water supply valve. It is recommended that you check whether the water pump is stuck at this time. If the water pump is stuck, remove the rear cover of the fan blade, rotate the motor shaft to a flexible state, and then work after confirming the safety. In addition, when the steam valve is opened and closed later, the valve face shall be kept away from the front to avoid accidents caused by steam water flushing out. When shutdown, close the steam valve first, and then close the water valve. Now it eliminates the blocking phenomenon from the structural principle. When there is whole-grain rice or starch concentration ≥ 25 in the powder, it is impossible to cause blockage. From the use of various manufacturers, jet liquefiers that have been in use for less than 2 years do not need to be disassembled and cleaned, which eliminates the defects of domestic jet liquefiers that are often blocked and cannot be produced continuously due to nozzle aperture and other reasons, especially the use of superheated steam.
In addition, when using the steam ejector, after the user sets the steam pressure, press and hold the start/stop button for 3 seconds, and the machine will start normally. When the upper limit of steam is set, the solenoid valve will automatically open to release steam. However, users are also advised to note that the steam outlet of their steam generator cannot be fully opened at this time. The balance between steam outlet and water inlet shall be maintained so as to better maintain continuous steam output and normal operation. Otherwise, all steam will be discharged at one time, which will affect the normal steam use effect of food production and processing. During the operation of the equipment we discussed today, the user should pay attention to checking all parts of the equipment and observe the pressure and water level. So please don't leave your post without permission. If the pressure of the steam injector rises to 0.2MPa and remains for 2 hours, stop burning, let the pressure gradually drop to zero, and the water temperature is lower than about 70 ℃. Open the blowdown valve to drain all water in the boiler. There are other important places. For example, after shutdown, the power switch should be turned off, the blowdown can only be started after the pressure drops to 0.1MPa, and the inlet valve should be closed at the same time. It is recommended to blow down the steam ejector every 24 hours. The blowdown method is to press the blowdown key and open the solenoid valve. At this time, turn on the blowdown switch inside the machine, and the internal water will flow out until it is dry.
In a word, you can come here for some information about the precautions in the operation and use of steam ejector. After reading the article, if you encounter this kind of thing, you will know which way to choose. I hope it can help you.
